Automated ESD Test System For Automotive Electronics
Model: ZAP-100

The system consists of an ESS-2000 ESD simulator, motor driven 3-axis mechanism discharge application unit and PC for the overall control.

GENERAL

A recently development in ESD testing is an automated ESD test system for automotive electronics specifically designed to apply ESD pulses to interface cables or connector pins under test. The standard system supports testing up to 100 pins (300 pins optional).

The Electrostatic Discharge Simulator Model: ESS-2000 in conjunction with a 3-axis motor-driven mechanism automatically applies discharges to the user-selected target pins and performs ESD testing in fully automated manner for all of the three discharge methods; air discharge, contact discharge and flashover tests. This innovative system greatly contributes to time and labor savings in standardized ESD tests.

FEATURES

• Standard system support testing for up to 100 pins
• Fully automated teasing by using windows application software
• User selectable test sequences
• Safety interlocked door on the plastic protection cover
• Contact discharge and two types of air discharge

SPECIFICATIONS

Applicable pin number Standard 100 Applied voltage Contact discharge 0.2~30.0 kV Air discharge: 5.0~30.0 kV Start/ Stop/ Step voltages freely set Polarity Positive or negative, Positive=>negative Discharge interval 0.05~ 327s No. of times of discharge 1~60000 times Discharge mode Contact discharge, Air discharge 1, Air discharge 2 DISCHARGE UNIT Drive system Cross angle robot by X-Y-X axis Discharge pins arrangement 10 x 10 Pitch between pins 20mm / Secures withstand voltage by partitions EUT connection Connectors provided to the discharge application unit for the EUT and associated controller or other device connection. Test pin Provided to visibly check discharges. Applicable ESD simulator and gun ESS-2000, TC-815R Dimensions (W) 500 x (H) 500 x (D) 650 mm PERSONAL COMPUTER/DRIVER Compatible machine IBM PC-AT compatible machine Main memory: 64MB or more Recommended CPU: Pentium® 200MH or higher OS Microsoft® Windows® 95/ Windows® 98 Interface card GP-IB (PCI-BUS) Motor control (PCI-BUS) Driver power supply AC100V, 300VA or below Driver dimensioms Approx. (W) 280 x (H) 100 x (D) 280 mm Microsoft® Windows® 95/98 are registered trademarks of Microsoft Corporation. Pentium® is a trademark of Intel Corporation.